Please note that User Registration has been temporarily disabled due to a recent increase in automated registrations. If anyone needs an account, please request one here: RequestAccount. Thanks for your patience!--Wmat (talk)
Please email User:Wmat if you experience any issues with the Request Account form.

Template:FLYSWATTER2 LPC2148 CONNECT

From eLinux.org
Jump to: navigation, search

Connecting the Flyswatter2 and the LPC2148 board

To hook up the Flyswatter2 and the LPC2148 board, you will need:


Connect the RS-232 Cable to the Flyswatter2.

Fs2 rs323.png


Connect the Other End of the Ribbon Cable to the LPC2148 board.

Fs2 lpc2148 rs323.png
There are two serial ports on the LPC2148. Either will work. If you use the port on the left (not the one shown in the picture), be sure the two switches in the blue housing near the port are set to OFF.


Connect the JTAG Cable.

Fs2 lpc2148 connected.png
Your cable should have a notch on each end to force it into correct alignment on the pins. If it doesn't align Pin 1 as shown in the image to the left. The red stripe on the cable marks Pin 1.


Connect the USB cable to the Flyswatter2.

Fs2 lpc2148 usb.png
Find the USB cable that comes with the Flyswatter2. Connect the B end (the square end, not the flat end) to the Flyswatter2.


Connect the Power Adapter to the LPC2148 board.

Fs2 lpc2148 power.png
The LPC2148 board's power supply is next to the right serial port.


Plug the Power Adapter into a Wall Outlet.

The red LED next to the LPC2148 board's power supply should come on and remain on.

Plug the USB Cable into your PC.

The green power LED on the Flyswatter2 should come on and remain on.