A13 OLinuXino-MICRO

From eLinux.org
Revision as of 16:39, 1 April 2013 by Matt Porter (Talk | contribs) (BDI-2000/3000)

Jump to: navigation, search

JTAG support

The A13 OLinuXino-MICRO has JTAG support brought out to an unpopulated 6-pin header next to the headphone jack. Solder a piece of header strip and it's ready to go.

Cabling

The table below shows the pinout for the proprietary JTAG header on the board. All pins are clearly silkscreened on the bottom of the board.

A13 OLinuXino JTAG Pin JTAG Signal ARM 20-pin JTAG ARM 14-pin
GND 1 GND 10 10
TDO 2 TDO 13 11
TCK 3 TCK 9 9
TMS 4 TMS 7 7
TDI 5 TDI 5 5
3.3V 6 3.3V  1 1

BDI-2000/3000

The A13 OLinuXino-MICRO BDI config file can be used with a BDI configured with the ARM11/Cortex-An firmware and the standard BDI ARM/Xscale 20-pin JTAG cable.

BDI2000 to A13 OLinuXino JTAG cabling

Flyswatter 2 / OpenOCD

The A13 OLinuXino OpenOCD config file can be used with a Flyswatter, OpenOCD, and the ARM 20-pin JTAG on the Flyswatter 2.

Usage:

 openocd -f interface/flyswatter2.cfg -f /tmp/a13-olinuxino.cfg