Revision as of 22:24, 19 November 2009 by Prpplague
APEX is a boot loader for embedded systems. It was written to support the Sharp LH series of wp:System_on_chip processors though it has been ported to a few other ARM targets including the Samsung S3C24xx series.
- Easy to build. It depends only on shell utilities and GCC.
- Easy to configure. There is a single configuration file and it uses the linux-2.6 Kconfig infrastructure.
- Excellent dependency management. Uses Linux kernel Kbuild to optimally manage dependencies.
- Modular. Commands and drivers may be included or excluded by configuration.
- Supported targets: LH79520, LH79524, LH7A400, LH7A404, IXP42x (e.g. Linksys NSLU2), S3C24xx, and iMX31.
- Support for RARP IP configuration and TFTP transfers to the target.
- Filesystem drivers for FAT, EXT2, and JFFS2.
- Partition driver for FIS as used by Redboot.
- Small footprint. A limited feature version can be as small as 16KiB.
- Support for booting APEX from non-memory-mapped storage, e.g. NAND flash, OneNAND, I2C