APEX Bootloader

From eLinux.org
Revision as of 00:29, 13 September 2007 by Prpplague (Talk | contribs)

Jump to: navigation, search

APEX is a boot loader for embedded systems. It was written to support the Sharp LH series of SystemOnChip processors though it has been ported to a few other ARM targets including the Samsung S3C24xx series.

o Easy to build. It depends only on shell utilities and GCC.
o Easy to configure. There is a single configuration file and it uses the linux-2.6 Kconfig infrastructure.
o Excellent dependency management. Uses Linux kernel Kbuild to optimally manage dependencies.
o Modular. Commands and drivers may be included or excluded by configuration.
o Supported targets: LH79520, LH79524, LH7A400, LH7A404, IXP42x (e.g. Linksys NSLU2), S3C24xx, and iMX31.
o Support for RARP IP configuration and TFTP transfers to the target.
o Filesystem drivers for FAT, EXT2, and JFFS2.
o Partition driver for FIS as used by Redboot.
o Small footprint. A limited feature version can be as small as 16KiB.
o Support for booting APEX from non-memory-mapped storage, e.g. NAND flash, OneNAND, I2C

Apex Project Page