Android Tutorials Unbox to App
Linaro Makes Development Boards Easy to Use
Many people think they need to do Android application development on a phone. This approach has a few drawbacks including:
* No standard development tools * Phone must be rooted * Schematics for the phone are not available * The code may not be completely open
Fortunately Linaro has created many images that developers can use to get the boards Linaro supports up and running quickly without searching through Wiki's, hanging out on IRC channels to get best-effort support or searching mailing lists.
These steps have been done against Panda, but the same steps will work on Linaro's iMX53, Origen, Beagle, Beagle xM and Snowball.
Unbox to Application Development
* HDMI 1080p monitor * USB keyboard and mouse * 5V, 2A Power Supply * HDMI Cable * Monitor Power Supply
|A close up of the power supply.|
|Unpack the Panda Board and connect the HDMI cable and the USB keyboard and mouse.|
|Optionally connect a serial-to-USB converter.|
|Connect an SD card reader|
|Insert your SD card.|
|Download a release from android-build.linaro.org.|
|The build page contains all the information necessary to program the build on an SD card. The following commands can be used to get and program a build.
wget --no-check-certificate https://android-build.linaro.org/jenkins/job/linaro-android_staging-panda-11.10-release/4/artifact/build/out/target/product/pandaboard/boot.tar.bz2 wget --no-check-certificate https://android-build.linaro.org/jenkins/job/linaro-android_staging-panda-11.10-release/4/artifact/build/out/target/product/pandaboard/system.tar.bz2 wget --no-check-certificate https://android-build.linaro.org/jenkins/job/linaro-android_staging-panda-11.10-release/4/artifact/build/out/target/product/pandaboard/userdata.tar.bz2 bzr branch lp:linaro-image-tools ./linaro-image-tools/linaro-android-media-create --mmc /dev/sdc --dev panda --system system.tar.bz2 --userdata userdata.tar.bz2 --boot boot.tar.bz2
A serial console thats logged to a file can be started to record boot:
minicom -D /dev/ttyUSB0 -w -C minicom.txt
|At the bottom of the build page is the build artifacts referenced in the instructions listed above.|
|Go to android.com and click on Developers.|
|Save android-sdk_r15-linux.tgz and untar it
tar -zxvf android-sdk_r15-linux.tgz
|Follow the steps listed at http://developer.android.com/sdk/installing.html for installing the SDK prerequisite and configuring the SDK to point to the tools that were just downloaded.|
|Install android's SDK
Run ./android-sdk-linux/tools/android and select the things shown in the clip.
|Open Disable Suspend.|
|Panda uses a Mini-B plug for ADB|
|Connect the Mini-B end to the board and the standard USB connector to the host. Run ./android-sdk-linux/platform-tools/adb shell ls|
|Run ./android-sdk-linux/platform-tools/adb shell ls to check that ADB is working.|