Please note that User Registration has been temporarily disabled due to a recent increase in automated registrations. If anyone needs an account, please request one here: RequestAccount. Thanks for your patience!--Wmat (talk)
Please email User:Wmat if you experience any issues with the Request Account form.

BeagleBoard with Arduino

From eLinux.org
Revision as of 03:50, 11 May 2011 by Prpplague (Talk | contribs)

Jump to: navigation, search

Getting the Arduino working on the BeagleBoard or BeagleBoard xM (Probably applies to the PandaBoard and similar platforms)

For recent Arduinos based on the Atmel USB chip (like the Arduino Uno) you will need to install the cdc-acm driver. You can do this in Angstrom using the following command:

opkg install kernel-module-cdc-acm

Your Arduino should then appear in /dev under the name ttyACM0 (note that the name is not the same as in OSX where it shows as tty.usbmodemXXXX)

For older Arduinos based on the FTDI chip, this is the driver to install :

opkg install kernel-module-ftdi-sio

I have not tested this so I am not sure under what name it will show up...

Thanks for prpplague for helping me sorting this out !