http://elinux.org/index.php?title=Buspirate.cfg&feed=atom&action=historyBuspirate.cfg - Revision history2013-05-21T09:39:15ZRevision history for this page on the wikiMediaWiki 1.21alphahttp://elinux.org/index.php?title=Buspirate.cfg&diff=127136&oldid=prevWmat: buspirate.cfg2012-05-08T10:42:30Z<p>buspirate.cfg</p>
<p><b>New page</b></p><div><syntaxhighlight code="tcl"><br />
#<br />
# Buspirate with OpenOCD support<br />
#<br />
# http://dangerousprototypes.com/bus-pirate-manual/<br />
#<br />
<br />
interface buspirate<br />
<br />
# you need to specify port on which BP lives<br />
#buspirate_port /dev/ttyUSB0<br />
<br />
# communication speed setting<br />
buspirate_speed normal ;# or fast<br />
<br />
# voltage regulator Enabled = 1 Disabled = 0<br />
#buspirate_vreg 0<br />
<br />
# pin mode normal or open-drain<br />
#buspirate_mode normal<br />
<br />
# pullup state Enabled = 1 Disabled = 0<br />
#buspirate_pullup 0<br />
<br />
# this depends on the cable, you are safe with this option<br />
reset_config srst_only<br />
<br />
</syntaxhighlight><br />
<br />
[[Category:OpenOCD]]<br />
[[Category:Debugging]]</div>Wmat