Please note that User Registration has been temporarily disabled due to a recent increase in automated registrations. If anyone needs an account, please request one here: RequestAccount. Thanks for your patience!--Wmat (talk)
Please email User:Wmat if you experience any issues with the Request Account form.

Difference between revisions of "Configuring a Static IP address on your Raspberry Pi"

From eLinux.org
Jump to: navigation, search
(Created page with "By default the Raspberry Pi uses DHCP to configure its network interfaces, including, on the model B, the built-in ethernet port. If you want to change this so the ethernet po...")
 
Line 1: Line 1:
 +
==  ==
 +
 
By default the Raspberry Pi uses DHCP to configure its network interfaces, including, on the model B, the built-in ethernet port. If you want to change this so the ethernet port has a static IP address, here's how.
 
By default the Raspberry Pi uses DHCP to configure its network interfaces, including, on the model B, the built-in ethernet port. If you want to change this so the ethernet port has a static IP address, here's how.
  

Revision as of 22:16, 23 December 2012

By default the Raspberry Pi uses DHCP to configure its network interfaces, including, on the model B, the built-in ethernet port. If you want to change this so the ethernet port has a static IP address, here's how.

DHCP for eth0 is enabled in the file /etc/network/interfaces. Here is what it looks like by default on a Raspberry Pi under the official version of Raspbian:

auto lo

iface lo inet loopback
iface eth0 inet dhcp

allow-hotplug wlan0
iface wlan0 inet manual
wpa-roam /etc/wpa_supplicant/wpa_supplicant.conf
iface default inet dhcp

(Note: there is no actual wlan0 interface unless you attach a wireless USB network adapter. The entries that refer to wlan0 are there for when you do ;-) ).

Instead of the line:

iface eth0 inet dhcp

you need lines like this:

iface eth0 inet static
address 192.168.1.1
netmask 255.255.255.0
gateway 192.168.1.254

The above example assigns the address 192.168.1.1 to eth0 with a subnet mask of 255.255.255.0, and sets the default gateway to 192.168.1.254.

Edit the file /etc/network/interfaces with the nano utility like this:

sudo nano /etc/network/interfaces

The second thing you need to do is check that you have a valid DNS server listed in /etc/resolv.conf. Edit this file using nano and add your DNS server if it is not already there. If you are using a broadband router, add the address of your router as the DNS server.