Difference between revisions of "Connecting to B3"

From eLinux.org
Jump to: navigation, search
(Created page with "==Connecting via USB== # 'Plug in B3 via USB cable to a PC'.")
 
Line 1: Line 1:
 
==Connecting via USB==
 
==Connecting via USB==
  
# 'Plug in B3 via USB cable to a PC'.
+
# '''Plug in B3 via USB cable to a PC'''.
 +
 
 +
The POWER LED lit steadily. This will power the board and provide a development interface.
 +
 
 +
BeagleBone will boot from the on-board 2GB eMMC and operates as a flash drive within 10 seconds.
 +
 
 +
The LEDs blink in their default configurations
 +
** USR0 is configured at boot to blink in a heartbeat pattern
 +
** USR1 is configured at boot to light during microSD card accesses
 +
** USR2 is configured at boot to light during CPU activity
 +
** USR3 is configured at boot to light during eMMC accesses

Revision as of 20:35, 4 September 2013

Connecting via USB

  1. Plug in B3 via USB cable to a PC.

The POWER LED lit steadily. This will power the board and provide a development interface.

BeagleBone will boot from the on-board 2GB eMMC and operates as a flash drive within 10 seconds.

The LEDs blink in their default configurations

    • USR0 is configured at boot to blink in a heartbeat pattern
    • USR1 is configured at boot to light during microSD card accesses
    • USR2 is configured at boot to light during CPU activity
    • USR3 is configured at boot to light during eMMC accesses