Devkit8000 Angstrom

From eLinux.org
Revision as of 09:59, 15 June 2011 by Yclinda666 (Talk | contribs)

(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to: navigation, search

This page gives some guide and suggestions on Angstrom development on Embest Devkit8000 board.

Angstrom Demonstration

Introduction

Angstrom was started by a small group of people who worked on the OpenEmbedded, OpenZaurus and OpenSimpad projects to unify their effort to make a stable and userfriendly distribution for embedded devices like handhelds, set top boxes and network-attached storage devices and more.

Preparations

1. One DevKit8000 Board
2. One SD card for demonstrate Angstrom
3. One DVI monitor (with one HDMI to DVI-D cable)
4. One USB mouse, one USB keyboard and one USB Hub (with external power)
5. One USB mini-A to USB A (female connector) cable
6. One 5V power adapter

Demonstration

1. Connect power well to Devkit8000 board;
2. Connect DVI monitor well to Devkit8000 board using HDMI to DVI-D cable;
3. Connect USB Hub well using USB Mini-A to USB A (female connector) cable, the USB Mini-A terminal is connected to Devkit8000 board while the USB A (female connector) terminal is connected to USB Hub, and connect USB mouse or USB keyboard to USB Hub;
4. Insert SD card and then power on Devkit8000;
5. Wait a moment, the DVI monitor will display logo;
6. After the system booted, the DVI monitor will remind the Angstrom startup progress;
7. After booting Angstrom successfully, it will get into graphic login inteface, please input user name and password to get into the system.

Remark

User name: embest
Password: embest
IP configuration command:
IP address: ifconfig eth0 192.192.192.77
getway address: route add default gw 192.192.192.101
Example
http://www.angstrom-distribution.org/demo/beagleboard/