Difference between revisions of "Flameman/eltek"
|Line 80:||Line 80:|
(P1-P2) chapter in Section 7.
(P1-P2) chapter in Section 7.
Revision as of 10:34, 16 July 2011
For more interesting projects done by Flameman, be sure to checkout his project index
The board has been made be synergy microsystem as V462 (dual processor) in V460 Series It seems the board+bsp+vxworks has been sold as "EUROCOM 27xxx"
- CPU: dual 33 MHz 68060 processors
- ram: 64 Mbytes, DRAM
- lan: Ethernet
- interface: Graphics, SCSI-2, VME 32/64?
- OS: comes with OS-9, LynxOS, pSOS+, PDOS, VxWorks
- Memory is provided on a piggyback module allowing it to be easily upgraded
- Up to 4 Mbytes of FLASH
- Supports ELTEC's LEB mezzanine bus
is this system (hw-2x68060/vxworks)s.m.p. or a.m.p. ?
- a.m.p. http://en.wikipedia.org/wiki/Asymmetric_multiprocessing
- s.m.p. http://en.wikipedia.org/wiki/Symmetric_multiprocessing
- n.u.m.a. there is also an other working schema, called "numa", seeFlameman/numa, useful with a great amount of cpu (cpu >> 8)
it seems that the dual-CPU V460 is featuring a symmetrical architecture allowing the two 68060 CPUs to operate as either tightly-coupled coprocessors sharing the same operating system and peripherals or as two independent CPUs running separate operating systems across separate I/O channels.
If this info is right it should be possible to assign different interrupt level schemes to each CPU via a programmable interrupt control register. In all of these possible arrangements, the dual CPU V460 Series can provide full multi-ported memory access by both CPUs, the VMEbus, and both EZ-bus modules with varying levels of memory protection as required.
V460 model (50 MHz, 8 MB RAM)
- +5.0v ±5% = 6.4 amps (typical)
- -12.0v ±5% = 30 mA
Pin row B of the P2 backplane is defined by VMEbus specifications and is bussed across the entire backplane. Pin rows A and C are user configured and, if con– nected at all, are normally connected to adjacent slots via wirewrap or special ca- bles. Because the P2 pinout may vary between backplanes or even slots in the same backplane, DO NOT INSTALL the V460 Series into a system slot whose P2 backplane is not compatible with the V460 Series’ P2 pin-out. Failure to observe this warning can cause the complete destruction of many on-board components and also voids the product warranty. The V460 Series pin-out meets standard VME specifications for row B, but rows A and C will vary according to the EZ-bus daughter module installed. Daughter board pinouts are shown in the associated daughter module manual. If no daughter module is present, P2 back- plane rows A and C are defined as no- connects. For a complete list of the V460 Series P2 assignments, see the VMEbus connectors (P1-P2) chapter in Section 7.
On V460 Series dual-68060 models, the following boot architecture is used:
- CPU-X executes from EPROM0 at 0xFE000000 to 0xFE0FFFFF
- CPU-Y executes from EPROM1 at 0xFE400000 to 0xFE4FFFFF or 0xFD000000 to 0xFDFFFFFF
except for the first 3 fetches in boot state in which CPU-X fetches from PROM0 and CPU-Y fetches from PROM1 either 68060 can execute from either or both of the EPROMs.