Difference between revisions of "Hammer Board HOWTOS"

From eLinux.org
Jump to: navigation, search
Line 30: Line 30:
  
 
[[Hammer_Uart2_Configuration|How to Configure Uart2]] on the [[Hammer_Board]]
 
[[Hammer_Uart2_Configuration|How to Configure Uart2]] on the [[Hammer_Board]]
 +
 +
[[Hammer_LED_Driver_Module]]
  
 
[[Category:TCT-Hammer]]
 
[[Category:TCT-Hammer]]
 
[[Category:TinCanTools]]
 
[[Category:TinCanTools]]

Revision as of 00:58, 5 June 2009

This is the index for the How-To section

Getting Started - A step by step guide to getting started with the Hammer_Board

How to add a Switching 5V regulator to the Hammer_Carrier

How to build a custom kernel for the Hammer_Board

How to build the buildroot and the kernel for the Hammer_Board

How to add a USB Thumb Drive to the Hammer_Board

How to add a USB Ethernet adapter to the Hammer_Board

How to use JFFS2 Flash for the root partition on Hammer_Board

How to add a USB FTDI Serial adapter to the Hammer_Board

How to add an ENC28j60 SPI ethernet interface to the Hammer_Board

TCPIP Networking, Getting the .config necessary for TCPIP to work.

How To Console Settings and minimal configurations for console interface.

How to reflash Apex & the Kernel

How use the flyswatter to recover from a bricked Hammer_Board

How to add an LCD to the Hammer_Board

How to Configure Uart2 on the Hammer_Board

Hammer_LED_Driver_Module