Difference between revisions of "Hammer Board HOWTOS"
Line 30: | Line 30: | ||
[[Hammer_Uart2_Configuration|How to Configure Uart2]] on the [[Hammer_Board]] | [[Hammer_Uart2_Configuration|How to Configure Uart2]] on the [[Hammer_Board]] | ||
+ | |||
+ | [[Hammer_LED_Driver_Module]] | ||
[[Category:TCT-Hammer]] | [[Category:TCT-Hammer]] | ||
[[Category:TinCanTools]] | [[Category:TinCanTools]] |
Revision as of 17:58, 4 June 2009
This is the index for the How-To section
Getting Started - A step by step guide to getting started with the Hammer_Board
How to add a Switching 5V regulator to the Hammer_Carrier
How to build a custom kernel for the Hammer_Board
How to build the buildroot and the kernel for the Hammer_Board
How to add a USB Thumb Drive to the Hammer_Board
How to add a USB Ethernet adapter to the Hammer_Board
How to use JFFS2 Flash for the root partition on Hammer_Board
How to add a USB FTDI Serial adapter to the Hammer_Board
How to add an ENC28j60 SPI ethernet interface to the Hammer_Board
TCPIP Networking, Getting the .config necessary for TCPIP to work.
How To Console Settings and minimal configurations for console interface.
How to reflash Apex & the Kernel
How use the flyswatter to recover from a bricked Hammer_Board
How to add an LCD to the Hammer_Board