Difference between revisions of "Hammer Board HOWTOS"

From eLinux.org
Jump to: navigation, search
Line 11: Line 11:
  
 
Next we will be soldering it on to the [http://elinux.org/Hammer_Carrier Hammer Carrier board]
 
Next we will be soldering it on to the [http://elinux.org/Hammer_Carrier Hammer Carrier board]
 +
 +
We will need an aux 3.3V regulator as the Enc28j60 can draw up to 250ma from its supply.
 +
Make sure that your 5V main power supply can supply the Hammer as well as the Enc28j60.
  
 
Insert picture of the result
 
Insert picture of the result
  
Insert picture of the wires soldered to the spi Vcc & Gnd points
+
Insert picture of the wires soldered to the spi VccAux & Gnd points
  
 
Software driver info:
 
Software driver info:

Revision as of 00:12, 1 August 2007

This is a place holder for the How-To section

How to get an Enc28j60 working on the Hammer board

First you have to get an Enc28j60, the following links may be usefull:

Next we will be soldering it on to the Hammer Carrier board

We will need an aux 3.3V regulator as the Enc28j60 can draw up to 250ma from its supply. Make sure that your 5V main power supply can supply the Hammer as well as the Enc28j60.

Insert picture of the result

Insert picture of the wires soldered to the spi VccAux & Gnd points

Software driver info:

The Good  Kernel SPI API
  The Bad  &
    The Ugly  The current "driver"