Difference between revisions of "Hammer Board HOWTOS"

From eLinux.org
Jump to: navigation, search
Line 19: Line 19:
 
[[Hammer_How_to_Enc28j60|How to add an ENC28j60 SPI ethernet interface]] to the [[Hammer_Board]]
 
[[Hammer_How_to_Enc28j60|How to add an ENC28j60 SPI ethernet interface]] to the [[Hammer_Board]]
  
[[Hammer_How_to_Networking|TCPIP Networking,]] Getting the .config neccessary for TCPIP to work.
+
[[Hammer_How_to_Networking|TCPIP Networking,]] Getting the .config necessary for TCPIP to work.
  
 
[[Hammer_How_to_Console|How To Console]] Settings and minimal configurations for console interface.
 
[[Hammer_How_to_Console|How To Console]] Settings and minimal configurations for console interface.

Revision as of 23:41, 2 January 2009

This is the index for the How-To section

Getting Started - A step by step guide to getting started with the Hammer_Board

How to add a Switching 5V regulator to the Hammer_Carrier

How to build a custom kernel for the Hammer_Board

How to build the buildroot and the kernel for the Hammer_Board

How to add a USB Thumb Drive to the Hammer_Board

How to add a USB Ethernet adapter to the Hammer_Board

How to use JFFS2 Flash for the root partition on Hammer_Board

How to add a USB FTDI Serial adapter to the Hammer_Board

How to add an ENC28j60 SPI ethernet interface to the Hammer_Board

TCPIP Networking, Getting the .config necessary for TCPIP to work.

How To Console Settings and minimal configurations for console interface.

How to reflash Apex & the Kernel

How use the flyswatter to recover from a bricked Hammer_Board

How to add an LCD to the Hammer_Board

How to Configure Uart2 on the Hammer_Board