Hammer Board HOWTOS

From eLinux.org
Revision as of 16:24, 31 July 2007 by KenMcGuire (talk | contribs)
Jump to: navigation, search

This is a place holder for the How-To section

How to get an Enc28j60 working on the Hammer board

First you have to get an Enc28j60, the following links may be usefull:

Next we will be soldering it on to the Hammer Carrier board

Insert picture of the result

Insert picture of the wires soldered to the spi Vcc & Gnd points

Software driver info:

The Good
  The Bad
    The Ugly