Hammer Board HOWTOS

From eLinux.org
Revision as of 17:12, 31 July 2007 by KenMcGuire (talk | contribs)
Jump to: navigation, search

This is a place holder for the How-To section

How to get an Enc28j60 working on the Hammer board

First you have to get an Enc28j60, the following links may be usefull:

Next we will be soldering it on to the Hammer Carrier board

We will need an aux 3.3V regulator as the Enc28j60 can draw up to 250ma from its supply. Make sure that your 5V main power supply can supply the Hammer as well as the Enc28j60.

Insert picture of the result

Insert picture of the wires soldered to the spi VccAux & Gnd points

Software driver info:

The Good  Kernel SPI API
  The Bad  &
    The Ugly  The current "driver"