Hammer Board HOWTOS

From eLinux.org
Revision as of 14:39, 1 August 2007 by Prpplague (Talk | contribs)

Jump to: navigation, search

This is a place holder for the How-To section

How to get an [[[Enc28j60 ENC28J60-H]]] working on the Hammer board

First you have to get an [[[Enc28j60 ENC28J60-H]]], the following links may be usefull:

Next we will be soldering it on to the [Hammer_Carrier Hammer Carrier board]

We will need an aux 3.3V regulator as the ENC28J60-H can draw up to 250ma from its supply. Make sure that your 5V main power supply can supply the Hammer as well as the ENC28J60-H.

Insert picture of the result

Insert picture of the wires soldered to the SPI, VccAux & Gnd points

Software driver info:

The Good  Kernel SPI API
  The Bad  &
    The Ugly  The current "driver"