Hammer Board HOWTOS
This is a place holder for the How-To section
How to get an Enc28j60 working on the Hammer board
First you have to get an Enc28j60, the following links may be usefull:
Next we will be soldering it on to the [Hammer_Carrier Hammer Carrier board]
We will need an aux 3.3V regulator as the ENC28J60-H can draw up to 250ma from its supply. Make sure that your 5V main power supply can supply the Hammer as well as the ENC28J60-H.
Insert picture of the result
Insert picture of the wires soldered to the SPI, VccAux & Gnd points
Software driver info:
The Good Kernel SPI API The Bad & The Ugly The current "driver"