Difference between revisions of "Hammer How to Enc28j60"

From eLinux.org
Jump to: navigation, search
Line 10: Line 10:
 
We will use the 3.3V regulator of the Hammier Carrrier, but you already need to have
 
We will use the 3.3V regulator of the Hammier Carrrier, but you already need to have
 
done the [[How_to_Swtching_5V_Regulator]]
 
done the [[How_to_Swtching_5V_Regulator]]
 +
 +
 +
Wire the ENC28J60 th the hammer carrier pins as follows:
 +
 +
enc -- hammer.  1 - 7, 2 - 6, 3 - 5, 4 - nc, 5 - 8, 6 - nc, 7 - 11, 8 - 9, 9 - gnd, 10 - tp9
  
 
Also make sure that your 5V main power supply can supply the Hammer as well as the ENC28J60-H.
 
Also make sure that your 5V main power supply can supply the Hammer as well as the ENC28J60-H.

Revision as of 06:44, 11 September 2007

First you have to get an Enc28j60, the following links may be usefull:

Next we will be soldering it on to the Hammer_Carrier

We will use the 3.3V regulator of the Hammier Carrrier, but you already need to have done the How_to_Swtching_5V_Regulator


Wire the ENC28J60 th the hammer carrier pins as follows:

enc -- hammer. 1 - 7, 2 - 6, 3 - 5, 4 - nc, 5 - 8, 6 - nc, 7 - 11, 8 - 9, 9 - gnd, 10 - tp9

Also make sure that your 5V main power supply can supply the Hammer as well as the ENC28J60-H.

Enc28j60.jpg

Enc28j60 wireing.jpg

Software driver info:

The Good  Kernel SPI API
  The Bad  &
    The Ugly  The current "driver"