Hammer How to Enc28j60

From eLinux.org
Revision as of 14:08, 11 September 2007 by Prpplague (Talk | contribs)

Jump to: navigation, search

First you have to get an Enc28j60, the following links may be usefull:

Next we will be soldering it on to the Hammer_Carrier

We will use the 3.3V regulator of the Hammier_Carrier, but you already need to have done the How_to_Swtching_5V_Regulator


Wire the Olimex Enc28j60 board to the Hammer_Carrier pins as follows:

ENC28J60 Pin Pin Hammer
1 7
2 6
3 5
4 N/C
5 8
6 N/C
7 11
8 9
9 GND
10 TP9

enc -- hammer. 1 - 7, 2 - 6, 3 - 5, 4 - nc, 5 - 8, 6 - nc, 7 - 11, 8 - 9, 9 - gnd, 10 - tp9

Also make sure that your 5V main power supply can supply the Hammer as well as the ENC28J60-H.

Enc28j60.jpg

Enc28j60 wireing.jpg

Software driver info:

The Good  Kernel SPI API
  The Bad  &
    The Ugly  The current "driver"