Difference between revisions of "Hammer How to Reflash Apex and kernel"

From eLinux.org
Jump to: navigation, search
m
 
Line 1: Line 1:
These instructions assume that apex has been configured for a 1024k kernel region
+
These instructions assume that [[APEX]] has been configured for a 1024k kernel region
  
 
=== Flashing a new kernel (zImage) ===
 
=== Flashing a new kernel (zImage) ===
Line 23: Line 23:
 
  apex> boot  <this will boot the existing kernel with the newly flashed rootfs>
 
  apex> boot  <this will boot the existing kernel with the newly flashed rootfs>
  
=== Flashing a new bootloader (apex) ===
+
=== Flashing a new bootloader ([[APEX]]) ===
  
 
  apex> xr 0x30008000
 
  apex> xr 0x30008000

Latest revision as of 00:16, 20 November 2009

These instructions assume that APEX has been configured for a 1024k kernel region

Flashing a new kernel (zImage)

You'll find the zImage file in the linux-2.6.22/arch/arm/boot directory.

apex> xr 0x30008000  <=== This is the address that the flash base kernel is copied to by apex on powerup>
< send zImage via xmodem>
apex> erase nor:256k+1024k
apex> copy 0x30008000+1024k nor:256k
1048576 bytes transferred
apex> boot  <this will boot the newly flashed kernel with the existing rootfs>

Flashing a new rootfs

You'll find the rootfs.arm.ext2.gz file in the buildroot/binaries/Hammer directory.

apex> xr 0x30800000  <=== This is the address that the flash base rootfs is copied to by apex on powerup>
<send rootfs.arm.ext2.gz via xmodem>
apex> erase nor:1280k+1024k
apex> copy 0x30800000+1024k nor:1280k
1048576 bytes transferred
apex> boot   <this will boot the existing kernel with the newly flashed rootfs>

Flashing a new bootloader (APEX)

apex> xr 0x30008000
< send apex.bin via xmodem>
apex> erase nor:0x00+256k   <<<yes this is correct, the 256k is intended to erase the entire block!
apex> copy 0x30008000+128k nor:0x00
131072 bytes transferred

then press reset to run the newly flashed apex, do not type boot

Notes on Using Minicom XMODEM

After typing the rx 0x30008000 command in the apex shell running Ctrl+A , S and using xmodem on minicom had to be done quickly. Best bet is to copy the path of the file into a clipboard and paste it. Otherwise type your path as fast as you can. I am not sure why it has this issue, may be an apex timeout on its rx command. Not Sure. But if you encounter that error just retry.