Initcall Debug

Revision as of 22:31, 15 September 2009 by Tim Bird (Talk | contribs) (Introduction: fix typo in sed command)

Jump to: navigation, search


Passing the option "initcall_debug" on the kernel command line will cause timing information to be printed to the console for each initcall. initcalls are used to initialize statically linked kernel drivers and subsystems and contribute a significant amount of time to the Linux boot process. The output looks like this:

calling ipc_init+0x0/0x28 @ 1
msgmni has been set to 42
initcall ipc_init+0x0/0x28 returned 0 after 1872 usecs

You can use 'dmesg' to see the messages after the kernel has booted. With a short 'sed' script, you can reorder the final 'timing' line, and sort the initcalls numerically by duration. Here is a command to do this:

dmesg -s 128000 | grep "initcall" | sed "s/\(.*\)after\(.*\)/\2 \1/g" | sort -n

Sample output

Here is some sample output from the above command sequence. This was on an old X86-based desktop system. Printk Times was turned on (hence the extra timestamp on each line.)

24 msecs [ 2.237177] initcall acpi_button_init+0x0/0x51 returned 0
28 msecs [ 0.763503] initcall init_acpi_pm_clocksource+0x0/0x16c returned 0
32 msecs [ 0.348241] initcall acpi_pci_link_init+0x0/0x43 returned 0
33 msecs [ 0.919004] initcall inet_init+0x0/0x1c7 returned 0
33 msecs [ 5.282722] initcall psmouse_init+0x0/0x5e returned 0
54 msecs [ 2.979825] initcall e100_init_module+0x0/0x4d returned 0
71 msecs [ 0.650325] initcall pnp_system_init+0x0/0xf returned 0
91 msecs [ 0.872402] initcall pcibios_assign_resources+0x0/0x85 returned 0
187 msecs [ 4.369187] initcall ehci_hcd_init+0x0/0x70 returned 0
245 msecs [ 2.777161] initcall serial8250_init+0x0/0x100 returned 0
673 msecs [ 5.098052] initcall uhci_hcd_init+0x0/0xc1 returned 0
830 msecs [ 4.067279] initcall piix_init+0x0/0x27 returned 0
1490 msecs [ 8.290606] initcall ip_auto_config+0x0/0xd70 returned 0


Using initcall_debug increases the amount of messages produced by the kernel during system boot. It's a good idea to increase the printk log buffer size to avoid overflowing the log buffer. To do this, increase the value of CONFIG_LOGBUF_SHIFT from 14 to 18. This increases the log buffer from the default size of 16k to 256K.