Please note that User Registration has been temporarily disabled due to a recent increase in automated registrations. If anyone needs an account, please request one here: RequestAccount. Thanks for your patience!--Wmat (talk)
Please email User:Wmat if you experience any issues with the Request Account form.

LeapFrog Pollux Platform: Hardwire Serial Connection

From eLinux.org
Revision as of 00:54, 10 May 2011 by Jsujjava (Talk | contribs)

Jump to: navigation, search

The serial console (115200 8N1) comes out to the cartridge connector.

  • Counting from the right
    • tx comes out on pin 12
    • rx on pin 11.

The UART is using +3.3V TTL level which means you will need a RS232_Level_Shifter or use one of the following usb->rs232 breakout boards:

Picture of the pinout of the Diji cartridge slot (Underside).

Picture from Claude Schwarz’s BLOG


TX, RX, GND, and VCC soldered directly to the pins.


  • Green UART-TX
  • Grey UART-RX
  • Black GROUND
  • Red +3.3V

The +3.3V isn't needed for all Uart connections, however some of the USB->RS-232 breakout boards may require a +3.3V reference voltage.