Difference between revisions of "LeopardBoard"

From eLinux.org
Jump to: navigation, search
(Hardware)
Line 1: Line 1:
The Leopard Board is a full featured, ultra low cost, small form factor, high performance development system which includes TMS320DM355 Processor board and a VGA camera board to provide VGA resolution video capture. The board is manufactured by leopard imaging and is available at [http://shop.leopardimaging.com/category.sc?categoryId=7].
+
The Leopard Board is a full featured, ultra low cost, small form factor, high performance development system which includes TMS320DM355 Processor board and a VGA camera board to provide VGA resolution video capture. The board is manufactured by leopard imaging and is available at [http://shop.leopardimaging.com/category.sc?categoryId=7]. A community website gives access to documentation and community forum [http://www.leopardboard.org leopardboard.org]
 
== Hardware ==
 
== Hardware ==
  

Revision as of 17:48, 23 August 2009

The Leopard Board is a full featured, ultra low cost, small form factor, high performance development system which includes TMS320DM355 Processor board and a VGA camera board to provide VGA resolution video capture. The board is manufactured by leopard imaging and is available at [1]. A community website gives access to documentation and community forum leopardboard.org

Hardware

  • Processor : TMS320DM355 Processor
  • NAND Flash : 2Gb Micron NAND Flash (256MB)
  • DDR2 SDRAM : 1Gb Micron DDR2 SDRAM (128MB)
  • Camera Interface :VGA CMOS Image Sensor by Default, Optional: 1.3M, 2M, 3M and 5 Megapixel CMOS Sensors supported
  • Audio In/Out :AIC3104I Audio chip, Stereo Audio In/Out, 2.5mm Stereo Plug connector
  • JTAG Port : JTAG Debugging Port
  • Serial Port : RS-232 UART Debugging Port, 2.5mm Stereo Plug connector
  • USB 2.0 Port : USB 2.0 HS (Device can be powered by USB port)
  • SD Card Slot : SD/MMC Slot
  • Power Management: TPS65053 Power management chip
  • Power Input : +5V Power Input, 2.1mm I.D. x 5.5mm O.D. x 12mm Female
  • Video Output Port : PAL/NTSC Output
  • Network Interface : 10/100 Ethernet
  • LCD/DVI Interface : LCD/DVI Interface through adapter board
  • Expansion Port (NotPopulated) : SD/MMC, I2C, UART, McBSP, GPIO, 3.3V power supply
  • PCB Board Mechanical : 3” x 2.5” (76.2mm x 63.5mm)
Leopard board.jpg