Please note that User Registration has been temporarily disabled due to a recent increase in automated registrations. If anyone needs an account, please request one here: RequestAccount. Thanks for your patience!--Wmat (talk)
Please email User:Wmat if you experience any issues with the Request Account form.


Revision as of 11:13, 8 May 2012 by Wmat (Talk | contribs)

(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to: navigation, search
# Luminary Micro Stellaris Evaluation Kits
# There are a number of evaluation kits for Stellaris Cortex-M3 chips.
# Currently they all bundle FT2232 based debug support.  When that is
# used (instead of an external adapter), use this config file in one
# of these two modes:
# - Eval board debug ... debug of the Stellaris chip via port A.
# - Other board debug ... same thing, but the board acts as a debug
#   adapter for another board (using a standard ARM JTAG connector).
#   The Stellaris chip stays in reset.
# Those support both JTAG and SWD.  SWD is an ARM-only two-wire debug
# protocol; in 2009, OpenOCD does not support SWD.
# Port B of the FT2232 chip is normally used as a serial link to the
# Stellaris chip.  On most boards (but not older LM3S811 eval boards),
# when SWD is used Port B may instead be used to read low-bandwidth
# "SWO trace" data, including so-called "printf style" output from
# firmware via the ITM module as well as profile data.
interface ft2232
ft2232_device_desc "Stellaris Evaluation Board"
ft2232_layout luminary_icdi
ft2232_vid_pid 0x0403 0xbcd9