Difference between revisions of "Marvell EBU:MacchiatoBin"
(More networking info) |
|||
Line 6: | Line 6: | ||
|- | |- | ||
| '''U-Boot (Marvell)''' || egiga0 || egiga1 || egiga2 || egiga3 | | '''U-Boot (Marvell)''' || egiga0 || egiga1 || egiga2 || egiga3 | ||
+ | |- | ||
+ | | '''U-Boot (2017.03-armada-17.06.3)''' || mvpp2-0 || mvpp2-3 || mvpp2-4 || mvpp2-5 | ||
|- | |- | ||
| '''Linux (upstream)''' || eth0 || eth1 || eth2 || eth3 | | '''Linux (upstream)''' || eth0 || eth1 || eth2 || eth3 |
Revision as of 05:11, 19 July 2017
Network interfaces
J6/CON15-CON16 | J7/CON17-CON18 | J5 | CON13-CON14 | |
---|---|---|---|---|
U-Boot (Marvell) | egiga0 | egiga1 | egiga2 | egiga3 |
U-Boot (2017.03-armada-17.06.3) | mvpp2-0 | mvpp2-3 | mvpp2-4 | mvpp2-5 |
Linux (upstream) | eth0 | eth1 | eth2 | eth3 |
U-Boot (Marvell) static ports configuration:
J6/CON15-CON16 | J7/CON17-CON18 | J5 | CON13-CON14 |
---|---|---|---|
SGMII | SFP+ | SFP+ | SFP+ |
Booting from netwrok
For the first mcbin board that were sent, the bootloader was U-Boot 2015.01-armada-17.02.0-g0f680c8. In this case the page Use network in U-Boot is relevant.
When using U-Boot 2017.03-armada-17.06.3-00339-ga33ecb8, in order to use the first port (the J5 connector close to the USB),then instead of using egiga2, mvpp4-2 must be use for ethact:
Marvell>> setenv ethact mvpp2-4
The other parts remain relevant.