Difference between revisions of "Minnowboard:Lures Specifications"
Line 94: | Line 94: | ||
* mSATA Connector | * mSATA Connector | ||
− | == Break-out-Board == | + | == Break-out-Board(aka 'BOB' Lure) == |
* Type-C Lure | * Type-C Lure | ||
Line 103: | Line 103: | ||
** UARTs | ** UARTs | ||
** usb host | ** usb host | ||
− | [[ | + | * [[MinnowBoard:Bob_Lure| BOB Lure Wiki Page]] |
== I/O Pad == | == I/O Pad == |
Revision as of 16:47, 8 July 2013
NOTE: The Lure Board Specifications are under development and are a "work in progress"
Lure Types
Type A
- 106.68mm x 106.68mm (4.2" x 4.2")
- Connector A99244-ND Female (digikey part number)
- Mated height 17mm (when mated with 5mm base)
- Hex Standoff 24436K-ND (digikey part number)
- Placement over top of board
- Four mounting holes at edges of minnow
Type B
- 62.25mm x 106.68mm (2.45" x 4.2")
- Connector A99231TR-ND Female (digikey part number)
- Mated height 10mm (when mated with 5mm base)
- Hex Standoff 24433K-ND (digikey part number)
- Placement over top of board
- Two screw mounting holes in center of minnow
Type-C
- 62.25mm x 62.25mm (2.45" x 2.45")
- Connector A99192TR-ND Female (digikey part number)
- Mated height 6mm (when mated with 5mm base)
- No mounting standoffs (needs review)
- Extends from side of minnow board
- No mount holes (needs review)
Lure Features
Minnow Board and Passthrough
- Connector A99205CT-ND Male (digikey part number)
- Mated height base 5mm (plus female connector height)
EEPROM
- i2c eeprom
- recommended size 256k
- CAT24C256W
- configurable for address
LVDS Interface
- single FPDLink-I interface (aka LVDS LCD interface)
- 18 or 24 bpp support
- Max pixel clock of 68MHz
- Max resolution 1366x768 (approximately 1120000 total pixels)
- Embedded Media Graphics Driver support
- UEFI controls (??)
- backlight PWM controls
- LVDS Controls Reference Documentation from Intel
- FPDLink-I to RGB888 bridge(aka LVDS to parallel)
- Presentation and References for LCD interfaces
Reference Lures
Beacon Lure
- Type-C Lure
- 7 Segment Display via Shift Register
- EEPROM
- PWM Controlled RGB LED
- Beacon Lure Page
Trainer Lure
- Type-A Lure
- Atmel AVR (Arduino Compatible)
- Prototype Area
- EEPROM
- Trainer Lure Page
- Trainer Lure Wiki Page
LVDS Lure
- Type-B Lure
- Backlight Power supply
- FPDLink-I connector (aka LVDS)
- EEPROM
- LVDS Lure Page
MiniPCIe / mSATA Lure
- Type-A Lure
- EEPROM
- miniPCIe Connector
- mSATA Connector
Break-out-Board(aka 'BOB' Lure)
- Type-C Lure
- Breakout for all low speed signals
- i2c
- spi
- gpio
- UARTs
- usb host
- BOB Lure Wiki Page
I/O Pad
- Type-B Lure
- 5 buttons
- 5 LEDS
- 2x10 Character LCD
- EEPROM
Automotive
- CAN bus interfaces
- 12V power input
- 12V switched power rails
- Voltage Sampling
- Automotive Lure wiki page