Pixter Dev Board - Revision history

Chris at 12:48, 14 July 2007

2007-07-14T12:48:31Z

Wmat: fixes

2007-03-01T03:48:49Z

fixes

Wmat: Legacy Content Conversion

2007-03-01T03:44:47Z

Legacy Content Conversion

New page

This is a Pixter taken apart and placed on a board for development. Currently this includes just the basics of touchscreen interface, power, calibrate button(GPIO), audio (PWM), and [[JTAG]]. On the todolist will be a duplication of the i/o pins (using a [[Pixter Dev Cart]]) available on the [[PixterExpansionSlot]] which will give rise to the addition of items such as [[Pixter MMC|mmc interface]], 10baseT nic, and rs-232 interfaces.

[[Image:pixdev.jpg]]

the opposite side of the main pixter board has a pair of solder pads which appear to be for a 0 ohm resistor. the pads have a pcb trace between the pads. this pad pair is stenciled "NCS0", which is the chip select for the onboard ROM. by cutting the trace between the pads the onboard ROM can be disabled. might be possible to find an unused or duplicate pin on the [[PixterExpansionSlot]] that can be replaced with the NCS0 line.

there are several other unidentified three pad areas with traces between two of the pads:

P100
P101
P102
P103

as well as one single pair marked "option"

[[Category Pixter]]

← Older revision		Revision as of 12:48, 14 July 2007
Line 19:		Line 19:


−		+	[[Category:Pixter]]
−	[[Category Pixter]]	+

← Older revision		Revision as of 03:48, 1 March 2007
Line 1:		Line 1:
−	This is a Pixter taken apart and placed on a board for development. Currently this includes just the basics of touchscreen interface, power, calibrate button(GPIO), audio (PWM), and [[JTAG]]. On the todolist will be a duplication of the i/o pins (using a [[Pixter Dev Cart]]) available on the [[~~PixterExpansionSlot~~]] which will give rise to the addition of items such as [[Pixter MMC\|mmc interface]], 10baseT nic, and rs-232 interfaces.	+	This is a Pixter taken apart and placed on a board for development. Currently this includes just the basics of touchscreen interface, power, calibrate button(GPIO), audio (PWM), and [[JTAG]]. On the todolist will be a duplication of the i/o pins (using a [[Pixter Dev Cart]]) available on the [[Pixter Expansion Slot]] which will give rise to the addition of items such as [[Pixter MMC\|mmc interface]], 10baseT nic, and rs-232 interfaces.


Line 5:		Line 5:


−	the opposite side of the main pixter board has a pair of solder pads which appear to be for a 0 ohm resistor. the pads have a pcb trace between the pads. this pad pair is stenciled "NCS0", which is the chip select for the onboard ROM. by cutting the trace between the pads the onboard ROM can be disabled. might be possible to find an unused or duplicate pin on the [[~~PixterExpansionSlot~~]] that can be replaced with the NCS0 line.	+	the opposite side of the main pixter board has a pair of solder pads which appear to be for a 0 ohm resistor. the pads have a pcb trace between the pads. this pad pair is stenciled "NCS0", which is the chip select for the onboard ROM. by cutting the trace between the pads the onboard ROM can be disabled. might be possible to find an unused or duplicate pin on the [[Pixter Expansion Slot]] that can be replaced with the NCS0 line.