Ppc Wait Mode
Table Of Contents:
This page has information about [technology area], which is of interest to CE Linux Forum members,
because [short rationale, or link to an introduction page]
Contents
CELF Technology/Project pages
- [link to public wiki technology page]
Documents
How to enter wait mode
WE bit in MSR register enables WAIT mode. You can find more information with following resources.
"2.10 Power Management" summarilze wait mode on PPC familly
- P352 on 440GP User's Manual
Figure 10-1. Machine State Register (MSR) 13 WE Wait State Enable 0 The processor is not in the wait state. 1 The processor is in the wait state. If MSR[WE] = 1, the processor remains in the wait state until an interrupt is taken, a reset occurs, or an external debug tool clears WE.
PM on PPC 4xx
PPC 4xx core has three PM state, "Active", "Standby" and "Sleep".
- "Stanby" stands for "pipeline is stopped, however clock is active". It means noraml(light) WAIT mode. - "Sleep" stands for "clock is stopped". It means deeper WAIT mode.
PPC Core FAQ (Ref: PPC440, PPC405) on IBM webiste says;
Q_20: The documentation mentions three power states; active, standby and sleep. Nowhere in the documentation have I found any detail on how those states are managed and exactly what happens in the non-active states. A_20: PowerPC 4XX CPU cores have several features that help conserve power: * First, the circuit implementation of the CPU cores automatically does clock gating to registers and latches when they are not being selected. * The CPU cores provide for program accessible means of stopping most activity by halting the execution pipeline. * Chip-top logic can be used to inactivate the clock enable inputs to the CPU or turn off the clocks external to the CPU core. * Chip-top logic can also be used to reduce the frequency of the clocks so that the CPU can continue to operate at a reduced capacity The power states are defined as: * Active: the normal operating mode where the CPU is executing instructions * Standby: CPU clocks are active; the execution pipeline is stopped; an interrupt will start execution. * Sleep: CPU clocks are inactive or gated off; CPU can not be restarted via software mechanism or interrupt. This must be done by chip-top logic external to the CPU core
How to enter "Sleep" state on PPC440
- Condtion where CPU enters "Sleep" state
This core sleep request signal is sent to a CPM unit to indicate that the core is requesting to be put into a sleep mode. This signal is asserted by the processor when the CPU is in the wait state, (i.e. MSR[WE] is set and no incomplete instructions are in progress, including APU instructions), the caches are idle (no fill or flush operations are in progress or pending), and the trace FIFO is empty.
- Condtion where CPU leave "Sleep" stete
Asserting following signal lines which are came from CPU core and are connected to CPM(Clock and Power managment Module), enter CPU "Sleep" state. So to leave from the state, those signals would be de-asserted. C440_cpmDECIrptReq Decrementer C440 _cpmFITIrptReq Fixed interval timer C440_cpmWDIrptReq WatchDog Output C440_cpmTimerResetReq 2nd reset from WatchDog C440_cpmMsrEE External Interrupt. In short, CPU timers can be used to leave "Sleep" state.