Please note that User Registration has been temporarily disabled due to a recent increase in automated registrations. If anyone needs an account, please request one here: RequestAccount. Thanks for your patience!--Wmat (talk)
Please email User:Wmat if you experience any issues with the Request Account form.

Difference between revisions of "RPI safe mode"

From eLinux.org
Jump to: navigation, search
(Added image of jumper wire in place)
Line 15: Line 15:
 
Be very careful with where you insert the jumper. Some pins carry power, so shorting those would not be a good idea. Third row from the end.
 
Be very careful with where you insert the jumper. Some pins carry power, so shorting those would not be a good idea. Third row from the end.
  
 +
[[File:Jump-pins-5-6.jpg|left|thumb|500px|20 AWG wire used to connect P1 pins 5 and 6 to boot RPi into safe mode. Also, 20 AWG wire insulation used to protect the power pins on the P1 header from accidentally being shorted to another pin or each other. ]]
 +
 +
<br />
  
 
More info:
 
More info:
 
http://www.raspberrypi.org/phpBB3/viewtopic.php?f=29&t=12007
 
http://www.raspberrypi.org/phpBB3/viewtopic.php?f=29&t=12007

Revision as of 18:22, 28 December 2012

This results in config.txt being ignored (except for avoid_safe_mode). A default cmdline.txt is applied, and kernel_emergency.img is loaded (if not available, then just kernel.img).

It provides a means of recovering from, e.g.

  • too high an overclock
  • a typo in cmdline.txt
  • an incorrect kernel=<filename> parameter
  • an invalid display mode

without requiring a PC. (Obviously it won't help if you've deleted start.elf...)

The busybox based kernel_emergency.img has /boot mounted, and vi installed so you can fix up config.txt or cmdline.txt. (You can also mount /dev/mmcblk0p2 and fix up the rootfs if you have problems there that stop you booting).

Short Jumpers 5&6. Be very careful with where you insert the jumper. Some pins carry power, so shorting those would not be a good idea. Third row from the end.

20 AWG wire used to connect P1 pins 5 and 6 to boot RPi into safe mode. Also, 20 AWG wire insulation used to protect the power pins on the P1 header from accidentally being shorted to another pin or each other.


More info: http://www.raspberrypi.org/phpBB3/viewtopic.php?f=29&t=12007