RPi Setting up a static IP in Debian
Using a static IP can be very useful in case you wish to easily access your RPi without need to get its IP address every time it boots or reconnects to the network (i.e. using SSH, (S)FTP services).
To achieve this there are a few quick steps to be followed.
You only need to modify the file /etc/networking/interfaces
You can edit the file with any text editor such as vi or vim.
We need root privileges, so we use sudo:
pi@raspberry:sudo vi /etc/networking/interfaces
In the file you must put the following content:
# The loopback interface auto lo iface lo inet loopback auto eth0 iface eth0 inet static #your static IP address 192.168.1.118 #your gateway IP gateway 192.168.1.1 netmask 255.255.255.0 #your network address "family" network 192.168.1.0 broadcast 192.168.1.255
Only the address and netmask data are required.
If for example your LAN is configured to have IP adresses in the range x.x.x.1 to x.x.x.255, you will put x.x.x.0 in the network line.
"address" is the IP you want the RPi will assume (in the proper range, as described above). pay attention not to use an IP already used by another device in your LAN or that can be assigned to a device by your router by DHCP (set the DHCP range of the router wisely).
"netmask" will "always" be 255.255.255.0
gateway is usually x.x.x.1 (your router IP or the one given by your ISP)
You now need to restart the network:
pi@raspberry:sudo /etc/init.d/networking restart
You may now be disconnected from your RPi if you are working through the network. Connect again to the RPi using the static IP you chose and you should now be fine.