RPi Through Hole break Out Box component list
- 1 Prices quoted are for guidence only
- 2 DIODE, ZENER, 1W, 3.3V, DO-41 (17 off)
- 3 WIRE, COPPER TINNED, 25SWG
- 4 RESISTOR, 330R, 0.25W, 5% (18 off)
- 5 HEADER, STRAIGHT, L/LATCH, 26WAY (1 off)
- 6 SOCKET, IDC, WITH STRAIN RELIEF, 26WAY (2 off)
- 7 RIBBON CABLE, 26WAY, PER METRE
- 8 Stripboard 25 X 64mm
- 9 TERMINAL BLOCK, PCB, SCREW, 5.0MM, 3WAY (4 off)
- 10 TERMINAL BLOCK, PCB, SCREW, 5.0MM, 4WAY (2 off)
- 11 LED LAMP, 3MM GREEN
Prices quoted are for guidence only
Prices were gathered from the websites quoted circa JULY 2012
Bigger savings can be made by bulk purchacing and items like tinned wire and vero board resistors could be used for other projects.
The suppliers are not the only source and bulk price savings can be made by checking out E-Bay etc.
DIODE, ZENER, 1W, 3.3V, DO-41 (17 off)
WIRE, COPPER TINNED, 25SWG
You are unlikely to need more than a foot which would imply you would be able to complete about 400 projects with even the shortest reel however considering the amount required for the project most hardware stores carry a card of fuse wire which would do at a push. This may proove dificult to solder.
Any insulated copper wire with a solid core (stripped of it's insulation) and of a diameter that will pass through the hole in a vero board will do and if you have
It is worth noting that a either reel of this would probably last you a lifetime of projects.
RESISTOR, 330R, 0.25W, 5% (18 off)
HEADER, STRAIGHT, L/LATCH, 26WAY (1 off)
SOCKET, IDC, WITH STRAIN RELIEF, 26WAY (2 off)
RIBBON CABLE, 26WAY, PER METRE
The ribbon cable is a commonly used industry standard and the length required for each project vairies, this ribbon cable can be salvaged from Old PC IDE and Floppy drive cables.
You want the older type that from PC's that did not use auto detect for hard drives It is easier to tell if you place them side by side the older one has a coarser structure (and that would be the type you need. Hard drive ide cable is 40 tracks (wires) wide but can easily be split down its length by hand.
One edge of the cable in the grey type usually has a red line indicating pin 1 but the wire inside is no different so this can be replicated witha felt tip pen.