Difference between revisions of "RPi Trinity Computer Club"

From eLinux.org
Jump to: navigation, search
(Installation of classroom RPIs from Wheezy image)
(Introduction)
Line 14: Line 14:
  
 
I created it in MS Word which I saved as a PDF for publication on this Wiki. If it proves useful enough, I will try and turn it into Wiki form.
 
I created it in MS Word which I saved as a PDF for publication on this Wiki. If it proves useful enough, I will try and turn it into Wiki form.
 +
[[Media:Trinity_RPi_Specification.pdf]]
 +
http://elinux.org/File:Trinity_RPi_Specification.pdf

Revision as of 20:51, 16 August 2012

Introduction

I am putting together a Computer Club for students at my school. This will be based on RPi Model B running the Raspbian “wheezy” image. The original intention was to prepare the RPi in advance for getting straight into programming in Python 3 and PyGame.

However, I am also wondering if the students I am looking for might, instead, prefer to setup the RPi for themselves from a vanilla wheezy install. Either way, after writing lots into a notebook as I worked out each stage of the setup process, I collected together what I had learned into an install document.

This consists of the following main sections:

1. Trinity School Raspberry Pi Specification - in which I summarise all the hardware and software I have included in my proposal to the Headteacher.

2. RPi Operating System Build - which is the main reason for creating this page - where I run through step by step the procedure needed to get from a headless RPi physically connected to the school network to being ready to start programming in Python 3.

3. Raspberry Pi Referece - a few useful snippets about the RPi.

I created it in MS Word which I saved as a PDF for publication on this Wiki. If it proves useful enough, I will try and turn it into Wiki form. Media:Trinity_RPi_Specification.pdf http://elinux.org/File:Trinity_RPi_Specification.pdf