Difference between revisions of "SparkFun: ADXL335, three-axis accelerometer"
m (moved Sparkfun: ADXL335 to Sparkfun: ADXL335, three-axis accelerometer: and make the name more descriptive)
Revision as of 13:15, 19 September 2012
The ADXL335 is a small, thin, low power, complete 3-axis accelerometer with signal conditioned voltage outputs. The product measures acceleration with a minimum full-scale range of ±3 g. It can measure the static acceleration of gravity in tilt-sensing applications, as well as dynamic acceleration resulting from motion, shock, or vibration.
Inputs and Outputs
The ADXL335 takes a supply voltage (Vs) of 1.8-3.6 V. The analog outputs are scaled proportionally to the supply voltage; at Vs = 3.6 V, the output will change by 2x for the same acceleration as compared to Vs = 1.8 V. Although the output sensitivity is scaled proportionally to the input voltage, noise is not, so higher supply voltages are advisable to reduce the impact of noise.
At all supply voltages, 0 g acceleration corresponds to an output voltage of Vs/2. At Vs = 3.6 V, the datasheet specs the typical sensitivity at 360 mV / g, with g as standard gravitational acceleration.
Because the ADXL335 has analog outputs, data can be read into the Bone via the analog input pins. The ADXL335 can be supplied either with the 1.8 V output on Pin 32 of P9, or with the standard 3.3 V supply.
Note: The maximum voltage for the Bone analog input is 1.8 V, so if the 3.3 V supply is chosen to power the ADXL335, a voltage divider must be used to reduce the output voltages to under 1.8 V. Two 10kOhm resistors have been used successfully for this purpose in the past.