Adafruit: Bicolor LED Square Pixel Matrix

From eLinux.org
Revision as of 18:36, 7 November 2012 by Draneaw (talk | contribs) (Current Status)
Jump to: navigation, search


Overview: 2
Wiring:   0
Code:     1
git/Compiles with make: 0
Demo:     0
Total:    3
Comments: It's good you have it working.  Now you need to fix up this page.
Assume you are writing to someone who wants to know how to use the device.  Show a picture
of it. Note the importance of soldering the display on correctly. Give wiring instructions.
Be specific, where do I wire the power?  Where does the clock go, etc.  How is the voltage
level converter wired in? Show a picture of the wiring.

Clean up Greg's code an put it in your github repository. Include a Makefile
Give me a demo.

Can you have this done in a week?  24-Oct-2012?

thumb‎ Embedded Linux Class by Mark A. Yoder


Page by Alex Drane, Peter Ngo

Summary

This page details project work done while working on the 8x8 Bicolor LED Pixel Matrix from Adafruit found here: Store Link

IMPORTANT!!! When soldering the led matrix to the controller make sure that it is placed correctly. If it is not, then the device will still communicate but the LED Matrix will not turn on.

Wiring Information

The device relies on the 5V source on the board and to insure functionality an I2C voltage level converter is used to boost the 3.3V I2C voltage to 5V. The voltage level converter is hooked up according to the photo. Starting from the top left of the device: SCL 5V, 5V Rail, Reset(Pulled up to 3.3V), SCL 3.3V In. Bottom Left: SDA 5V, Ground, 3.3V, SDA 3.3V.

The LED Matrix is wired from left to right: 5V, Ground, SDA, SCL.

The tenth pin from the Right on row 1 of the P9 IO Rail on the Beagle (Count from the 5V Line in) is the SCL pin and the pin on row 2 is the SDA pin. Starting from the right on P9 top row is: Ground, 3.3V, Skip, 5V.

Wiring Diagram