Android Fastboot

From eLinux.org
Revision as of 15:07, 1 August 2009 by Tim Bird (talk | contribs) (Special boot mode: add link to fastboot-mode image)
Jump to: navigation, search

Introduction

Fastboot is the name of a tool used to manipulate the flash partitions of the Android developer phone. It can also boot the phone using a kernel image or root filesystem image which reside on the host machine rather than in the phone flash. In order to use it, it is important to understand the flash partition layout for the ADP1.

The fastboot program works in conjunction with firmware on the phone to read and write the flash partitions. It needs the same USB device setup between the host and the target phone as adb.

Special boot mode

To use fastboot, you have to reboot the phone into the special 'fastboot' mode. Do this by turning off the phone, then booting the phone, holding down the camera button on the side of the phone, while pressing the power button.

You can tell you are in 'fastboot' mode when you see a screen with drawings of 3 Androids riding skateboards, on a white background.

The yellow line in the middle of the screen will say "Serial0" until you plug in the USB cable, and press the "back" key. Once you do this, after a few seconds the yellow line will switch to saying "FASTBOOT".

Fastboot-mode.jpg

At this point you are ready to send commands and/or data to the phone using the fastboot program on your host.

Flash partitions

Flash partitions on the ADP1

Partition name Device Size Contents/Notes
splash1 or misc /dev/mtd/mtd0 262K splash screen image. This partition is called 'splash1' by fastboot, but 'misc' by the Linux kernel
recovery /dev/mtd/mtd1 5.2M kernel, initrd with rootfs (for alternate boot)
boot /dev/mtd/mtd2 2.6M kernel, initrd with rootfs (for default boot)
system /dev/mtd/mtd3 70M yaffs2 file system, mounted read-only at /system - has the bulk of the Android system, including system libraries, Dalvik and pre-installed applications.
cache /dev/mtd/mtd4 70M yaffs2 file system, mounted at /cache - only used on G1 for over-the-air updates. This partition can be used to store temporary data.
userdata /dev/mtd/mtd5 78M yaffs2 file system, mounted at /data - contains user-installed applications and data, including customization data

Resources

Good cheat sheet at: http://andblogs.net/fastboot/

You can download binaries of 'fastboot' from: http://www.htc.com/www/support/android/adp.html (see the table about the 1/4 down the page)