Animal LVDS Mini Board
Animal LVDS Mini Board is an expansion board for BeagleBoard Rev-C, BeagleBoard-xM, PandaBoard, PandaBoard-ES and compatible clones. For an introduction to LVDS display panels, please visit HERE. The
- I2C interface for EDID communication
- 4 Backlight PWM/ENABLE controls
- LVDS interface via a SN75LVDS83B
- 18-bit mode
- 24-bit 2-LSB mode
- 3.3V I2C interface
- BeagleBoard Rev-C - Note: requires headers to be populated
- PandaBoard-ES (4460) - Note: requires headers to be populated
- PandaBoard (4430) - Note: requires resistors and headers to be populated
Note: there are wide range of BeagleBoard clones available on the open market. the Animal LVDS Mini may work with these board but are not tested or guaranteed to work with them.
Supported LCD Panels with IPEX 20455 Connector
- Pixel Qi Model 3QI available from MakerShed
- LG LP101WSA-TLA1
- ChiMei: N101L6-L Series
- AUO B101AW01 Series
- Samsung LTN101NT02 series
- HANN STAR HSD101PFW2 series
- Laptop Models Displays
- DELL MINI 10 (10.1" LED BACKLIGHT PANEL)
- Acer Aspire one (10.1" LED BACKLIGHT PANEL)
- LENOVO IdeaPad S10-2 (10.1" LED BACKLIGHT PANEL)
- ASUS Eee PC (10.1" LED BACKLIGHT PANEL)
- HP 2133,2140/5101
- HP Mini 1000 / 210-1000 ~ 1099
- Compaq Mini 210c-1000~1099
- ACER DELL EPC10
- Lenovo S10-2
The above picture illustrates the typical cable connections.
- Animal LVDS Mini Board - this board uses a standard 0.1" x 0.1" pitch 40-pin connector as it's output interface. It will interface to standard 40-pin ribbon cables (i.e. 40-pin IDE cables).
- 40-pin Ribbon Cable - the length of this cable can be varied from 1" to 36" (we have tested cables up to 36" in length).
- LVDS 20455 Adapter - this board simply converts the 40-pin ribbon cable to a standard 40-pin LVDS surface mount connector (I-PEX p/n: 20455-040E-12).
- LVDS Cable Assembly - this LVDS cable assembly length is 6". We intentionally kept this cable short to keep the cost down. You can use longer LVDS cable assemblies without any problem.
- LVDS LCD - standard LVDS LCD's (i.e. Pixel Qi 10.1" PQ3Qi-01 or 10.1" Chunghwa CLAA101NB01)
- Animal LVDS Mini Schematic
- TI SN75VLDS83B Datasheet
- NXP PCA9633 Datasheet
- LVDS 20455 Adapter Schematic
- I-PEX 20455-040E-12 surface mount LVDS connector
- Pixel Qi PQ3Qi-01 10.1" LVDS LCD Datasheet
- Chunghwa CLAA101NB01 10.1" LVDS LCD Datasheet
- Core display support uses the OMAP DSS driver.
- Mainline support for the panel-generic-dpi driver
- Support for the PWM backlight driver is provided as a patch.
- Support will be provided for the following distros
- Ubuntu for PandaBoard
- Angstrom for PandaBoard and BeagleBoard
- AOSP(Android) for PandaBoard
- other support will be provided on a case by case basis