EBC Exercise 08a Cross-Compiling
Embedded Linux Class by Mark A. Yoder
This class is about developing software for embedded Linux. So far we have been doing all of our development on the Beagle. This works well for small (and not so small) programs. However, we are now moving into kernel development and that's best done on a more powerful host computer. In EBC Exercise 08 Installing Development Tools you learned how to download and install the cross-compilers and the source for kernel and u-boot. Now we'll use those tools.
Cross-compiling Hello World
This shows how to cross-compile with compiler loaded with
host$ sudo apt-get install -y git lzop gcc-arm-linux-gnueabi uboot-mkimage
Listing 2-4 on page 29 of the text is an embedded version of Hello World. If you've set up your git repository you will find it in helloWorld.c when you do a git pull. Compile and run it on your host to be sure it works.
host$ gcc helloWorld.c host$ file a.out a.out: ELF 32-bit LSB executable, Intel 80386, version 1 (SYSV), dynamically linked (uses shared libs), for GNU/Linux 2.6.24, BuildID[sha1]=0x357e34e90f7c32d414368d69cc06d0aed59acf1c, not stripped host$ ./a.out Hello, World! Main is executing at 0x400524 This address (0x7fff8260bdf8) is in our stack frame This address (0x601038) is in our bss section This address (0x601020) is in our data section
Now that you know it's working, let's cross compile it. First set the paths to find the cross-compiler. Put the following in a file, call it ~/.oe/crossCompileEnv.sh.
export ARCH=arm export CROSS_COMPILE=arm-linux-gnueabi-
Now source the file and compile again. (Note: you only have to source once per terminal session.)
host$ source ~/.oe/crossCompileEnv.sh host$ ${CROSS_COMPILE}gcc helloWorld.c host$ file a.out a.out: ELF 32-bit LSB executable, ARM, version 1 (SYSV), dynamically linked (uses shared libs), for GNU/Linux 2.6.31, BuildID[sha1]=0x10182364352b9f3cb15d1aa61395aeede11a52ad, not stripped
The file command tells what's in the file. In this case we have an ARM executable. Success! Now copy to your Beagle and run
host$ scp a.out root@beagle:. host$ ssh root@beagle ./a.out Hello, World! Main is executing at 0x8374 This address (0xbeb32d4c) is in our stack frame This address (0x10650) is in our bss section This address (0x10648) is in our data section
The scp copies a.out to the beagle and the ssh runs the a.out on the beagle. Notice the addresses are very different from the host version.
Embedded Linux Class by Mark A. Yoder