Hack A10 devices

From eLinux.org
Revision as of 22:50, 25 December 2011 by Hipboi (talk | contribs) (Get a console)
Jump to: navigation, search

Hack A10 Devices

This page describe how to hack a A10 powered tablet and let a custom kernel to run on the tablet. The work was done on an Ainol Novo 7 Advanced tablet. But should be working on all A10 based tablet. Since A10 can boot from usb, never worry about bricking your device.

First sight

The stock firmware in my Novo7 is android 2.3.4. With android adb i can log into the device and take a look at inside.

# mkdir /sdcard/nanda
# mount -t vfat /dev/block/nanda /sdcard/nanda
# ls /sdcard/nanda
# ls /sdcard/nanda/linux
# cat /sdcard/nanda/linux/linux.ini
img_name = c:\linux\bImage
img_size = 0x2000000
img_base = 0x40008000

img_name = c:\linux\params
img_size = 0x100
img_base = 0x40000100

script_base = 0x43000000
script_size = 0x10000

logo_name = c:\linux\android.bmp
logo_address = 0x48000000
logo_show = 1

As you can see the linux/bImage is our kernel, and the linux/linux.ini is a config file that some loader reads, and load the file bImage to 0x40008000 address. And the file linux/params is the kernel cmdline.

# cat /sdcard/nanda/linux/params
console=ttyS0,115200 root=/dev/nandb rw init=/init fbmem=32M@0x5a000000 loglevel=8;

And recovery.ini and paramsr is for android recovery boot and cmdline.

Get a console

Allwinner uses a config file for hardware configuration, a config file is a Windows ini file, you can download the config file for novo7 advanced here, which is something like this.

uart_debug_port          = 0
uart_debug_tx            =port:PB22<2>
uart_debug_rx            =port:PB23<2>

The A10 uart rx and tx pin can be configured by software, usually PB22 and PB23 are for uart rx and tx, PF2 and PF4 for sdcard. But software can change this, let PF2 and PF4 be the uart rx and tx and disable sdcard, thus the usual sdcard clock pin and data3 pin is uart rx and tx. So with a TTL serial to USB cable, you can get a console from the sdcard slot.

change the following two places in the sys_config1.fex

uart_debug_port          = 0
uart_debug_tx            =port:PB22<2>
uart_debug_rx            =port:PB23<2>
uart_used                = 1
uart_port                = 0
uart_type                = 2
uart_tx                  =port:PB22<2>
uart_rx                  =port:PB23<2>


uart_debug_port          = 0
uart_debug_tx            =port:PF2<2>
uart_debug_rx            =port:PF4<2>
uart_used                = 1
uart_port                = 0
uart_type                = 2
uart_tx                  =port:PF2<2>
uart_rx                  =port:PF4<2>

To get the param working you need another tool, called script, download the linux version here