Difference between revisions of "Hammer How to Enc28j60"
KenMcGuire (talk | contribs) |
KenMcGuire (talk | contribs) |
||
Line 10: | Line 10: | ||
We will use the 3.3V regulator of the Hammier Carrrier, but you already need to have | We will use the 3.3V regulator of the Hammier Carrrier, but you already need to have | ||
done the [[How_to_Swtching_5V_Regulator]] | done the [[How_to_Swtching_5V_Regulator]] | ||
+ | |||
+ | |||
+ | Wire the ENC28J60 th the hammer carrier pins as follows: | ||
+ | |||
+ | enc -- hammer. 1 - 7, 2 - 6, 3 - 5, 4 - nc, 5 - 8, 6 - nc, 7 - 11, 8 - 9, 9 - gnd, 10 - tp9 | ||
Also make sure that your 5V main power supply can supply the Hammer as well as the ENC28J60-H. | Also make sure that your 5V main power supply can supply the Hammer as well as the ENC28J60-H. |
Revision as of 06:44, 11 September 2007
First you have to get an Enc28j60, the following links may be usefull:
Next we will be soldering it on to the Hammer_Carrier
We will use the 3.3V regulator of the Hammier Carrrier, but you already need to have done the How_to_Swtching_5V_Regulator
Wire the ENC28J60 th the hammer carrier pins as follows:
enc -- hammer. 1 - 7, 2 - 6, 3 - 5, 4 - nc, 5 - 8, 6 - nc, 7 - 11, 8 - 9, 9 - gnd, 10 - tp9
Also make sure that your 5V main power supply can supply the Hammer as well as the ENC28J60-H.
Software driver info:
The Good Kernel SPI API The Bad & The Ugly The current "driver"