Jetson nsight system

From eLinux.org
Revision as of 23:49, 4 January 2021 by Mchi (talk | contribs)
Jump to: navigation, search

This page describes how to use Nsight System on Jetson L4T system

Installation

Install NS on x86 Linux Host

1. Install Nsight System via SDKManager

Then, click Continue to install Nsight System on x86 Linux System.

2. Verify Installation

After installation is done, you can open it with "nsight-sys" command as below.

Install NS on Jetson Device

Note: on the newly installed Jetson system, there is not Nsight System on it.
So, to install Nsight System on Jetson device, you need to

  1. On x86, launch the Nsight system installed via SDKManager as described above
  2. In Nsight System, create a new project, and connect to Jetson device as below, this step will install the Nsight target binaries ontO Jetson device

Profile

Remote Profile

Local Profile