Difference between revisions of "JuiceWare Xd Socket4"

From eLinux.org
Jump to: navigation, search
m (Bot (Edward's framework))
 
 
(One intermediate revision by one other user not shown)
Line 2: Line 2:
  
 
[[Image:19-JB-XD-a.jpg]]
 
[[Image:19-JB-XD-a.jpg]]
----Next build the [[JuiceWare Test Image]]. Use [[JuiceBoxJTAG]] interface to write the image to the xD card. Once the image is written power cycle the [[JuiceBox]] and you should see the "Juicebox demo #2" running.
+
----Next build the [[JuiceWare Test Image]]. Use [[JuiceBox_JTAG]] interface to write the image to the xD card. Once the image is written power cycle the [[JuiceBox]] and you should see the "Juicebox demo #2" running.
  
 
[[Image:21-JB-XD-a.jpg]]
 
[[Image:21-JB-XD-a.jpg]]
Line 11: Line 11:
 
Next: [[JuiceWare Xd Socket5]] - Troubleshooting
 
Next: [[JuiceWare Xd Socket5]] - Troubleshooting
 
Back to main [[JuiceWare Xd Socket]] menu.
 
Back to main [[JuiceWare Xd Socket]] menu.
 +
 +
[[Category:JuiceBox]]

Latest revision as of 02:12, 14 July 2007


This is a good point at which to test the unit. Plug it in without the xD card to make sure that the Juicebox powers up. Running the mem tests (hold play and rewind as you power it up) should indicate there is no MMC or cartridge detected. Now power down and put an xD card in the socket. The mem test should detect that there is a cartridge and will show a manufacturer ID and memory size. If everything is working properly you will get the same checksum each time the test is run.

19-JB-XD-a.jpg


Next build the JuiceWare Test Image. Use JuiceBox_JTAG interface to write the image to the xD card. Once the image is written power cycle the JuiceBox and you should see the "Juicebox demo #2" running.

21-JB-XD-a.jpg


At this point the unit should be fully functional. If there are any problems see the troubleshooting section JuiceWare Xd Socket5. Get everything working before proceeding.

You may want to glue the top half of the cartridge to the PCB for added strength. Don't get any glue into the socket or on the gold fingers. In case there is a problem in the future (loose wire etc.) it is best not to glue the back half on, the two screws will be enough to hold it together.


Next: JuiceWare Xd Socket5 - Troubleshooting Back to main JuiceWare Xd Socket menu.