Difference between revisions of "Panda How to add Power Switch"
KenMcGuire (talk | contribs) |
KenMcGuire (talk | contribs) |
||
| Line 46: | Line 46: | ||
* First few pins of J6 | * First few pins of J6 | ||
| − | [[image: | + | [[image:j6_detail3.jpg|800px]] |
[[Category:PandaBoard]] | [[Category:PandaBoard]] | ||
Revision as of 10:46, 4 May 2011
Contents
Introduction
- The J6 expansion header on the PandaBoard allows for the addition of a power switch.
This is a Work In Progress, don't go by anything below this line.
Materials
These are the materials you will need in addition to your Pandaboard.
- Momentary Push Button Switch
- Available from:
- A 2 x X pin header .1" centers
- Available from:
Pinout
- J6 Pinout
Assembly
Here is what the header will look like when soldered to J6 of the Pandaboard.
- Solder the header into the J6 pins closest to the WIFI module
- Detail of the header soldered into J6
Notes
- First few pins of J6
