R-Car/Boards/Kingfisher
Introduction
This is the official Wiki for Kingfisher Infotainment Board.
Hardware
This section contains information about Kingfisher Board hardware.
Board Layout
Hardware Features
- Ethernet AVB phy
- KSZ9031 phy
- MOST interface
- Support both 3-pin and 6-pin MLB interface
- Pinout compatible with Microchip evaluation boards
- LVDS camera interface
- MAX9272 deserializer
- 8-bit wide video bus connected to VI2 interface of R-Car M2 CPU
- 5V or 12V selectable supply voltage for camera with current limiting
- High quality 24-bit audio codec PCM3168A
- 8 input channels (4 stereo jacks for microphone connection)
- 6 line out channels (RCA connectors)
- 6 HP outputs (3 stereo jack connectors for direct headphones connection)
- 44100/48000 Hz sampling frequency
- Two USB 3.0 ports
- USB port supports host, device and OTG modes
- SD card slot
- Si4689 base AM/FM/DAB radio
- Digital audio interface to R-Car M2 CPU
- Additional flash storage for fast radio boot
- Supply for active DAB antennas with current limit (5 or 12 V)
- GPS/GLONASS receiver
- Serial and i2c interface to R-Car
- 9-axis sensor:
- 3D digital linear acceleration sensor
- 3D digital angular rate sensor
- 3D digital magnetic sensor
- WiFi/BT module Texas Instruments WL1837
- Power supply: 12V, 9 Amps