Difference between revisions of "R-Car/Boards/Salvator-X"

From eLinux.org
Jump to: navigation, search
(Test procedures)
(Extend for R-Car M3-W.)
Line 5: Line 5:
 
== Introduction ==
 
== Introduction ==
  
This is the Wiki for the Renesas R-Car H3 Salvator-X board (RTP0RC7795SIPB0010S).
+
This is the Wiki for the Renesas R-Car H3 and M3-W Salvator-X boards (RTP0RC7795SIPB0010S resp. RTP0RC7796SIPB0011S).
 
Refer to the [[R-Car]] page for information about Renesas' R-Car SoC family.
 
Refer to the [[R-Car]] page for information about Renesas' R-Car SoC family.
  
Line 17: Line 17:
 
   * Kernel config: defconfig
 
   * Kernel config: defconfig
 
   * Kernel image: arch/arm64/boot/Image
 
   * Kernel image: arch/arm64/boot/Image
   * DTB: arch/arm64/boot/dts/renesas/r8a7795-salvator-x.dtb
+
   * DTB: arch/arm64/boot/dts/renesas/r8a7795-salvator-x.dtb (for R-Car H3)
 +
  * DTB: arch/arm64/boot/dts/renesas/r8a7796-salvator-x.dtb (for R-Car M3-W)
 +
 
  
 
U-Boot boot command:
 
U-Boot boot command:
 
<pre>
 
<pre>
 
tftpboot 0x48080000 Image
 
tftpboot 0x48080000 Image
tftpboot 0x48f00000 r8a7795-salvator-x.dtb  
+
tftpboot 0x48f00000 r8a7795-salvator-x.dtb (for R-Car H3)
 +
tftpboot 0x48f00000 r8a7796-salvator-x.dtb (for R-Car M3-W)
 
booti 0x48080000 - 0x48f00000
 
booti 0x48080000 - 0x48f00000
 
</pre>
 
</pre>

Revision as of 06:44, 13 September 2016

Renesas Salvator-X

Introduction

This is the Wiki for the Renesas R-Car H3 and M3-W Salvator-X boards (RTP0RC7795SIPB0010S resp. RTP0RC7796SIPB0011S). Refer to the R-Car page for information about Renesas' R-Car SoC family.

Serial Console

Use a micro-USB cable to connect to "Debug Serial 0". Serial settings are 115200 8N1.

Booting Linux

 * Kernel config: defconfig
 * Kernel image: arch/arm64/boot/Image
 * DTB: arch/arm64/boot/dts/renesas/r8a7795-salvator-x.dtb (for R-Car H3)
 * DTB: arch/arm64/boot/dts/renesas/r8a7796-salvator-x.dtb (for R-Car M3-W)


U-Boot boot command:

tftpboot 0x48080000 Image
tftpboot 0x48f00000 r8a7795-salvator-x.dtb (for R-Car H3)
tftpboot 0x48f00000 r8a7796-salvator-x.dtb (for R-Car M3-W)
booti 0x48080000 - 0x48f00000

Test procedures

  • Tests:SCIF-FIFO: Test SCIF FIFO behavior, using SCIF3 and HSCIF3 on expansion I/O connectors
  • Tests:SDIO-KS7010: Test SDIO with a Spectec SDW823 microSD card (using an SD size adapter) on connectors CN13 or CN14
  • Tests:SDIO-H3-Voltage-Switching: Test if voltages change properly when inserting UHS capable SD cards into connectors CN13 or CN14
  • Tests:Watchdog-Pretimeout: Test watchdog pretimeouts. Because the hardware watchdog (RWDT) doesn't support this feature, a software watchdog must be used in addition