Difference between revisions of "R-Car/Boards/V3MSK"
Line 33: | Line 33: | ||
Image-r8a7797-v3msk-kf.dtb | Image-r8a7797-v3msk-kf.dtb | ||
Image-r8a7797-v3msk-kf-v0.dtb | Image-r8a7797-v3msk-kf-v0.dtb | ||
+ | Image-r8a7797-v3msk-vb.dtb | ||
</pre> | </pre> | ||
Revision as of 08:41, 5 November 2017
Introduction
This is the Wiki for the Renesas R-Car V3M Starter Kit board (RTP0RC7797....). Refer to the R-Car page for information about Renesas' R-Car SoC family.
Where to buy
TBD
V3M Starter Kit Board Documentation
TBD
System with LVDS cameras
TBD
Quick Start
Build BSP images
Please follow these instruction to build BSP http://elinux.org/R-Car/Boards/Yocto-Gen3-ADAS#Building_the_BSP_for_Renesas_ADAS_boards:
At step 5,6 - skip these steps
At step 8 - replace this step with following:
cp $WORK/meta-rcar/meta-rcar-gen3-adas/docs/sample/conf/v3msk/linaro-gcc/bsp/*.conf ./conf/
At step 9,10,11 - skip these steps
At step 13 - replace this step with following:
bitbake core-image-minimal
At step 16 use images for V3M Starter Kit board or ULCB Kingfisher board:
Image-r8a7797-v3msk.dtb Image-r8a7797-v3msk-kf.dtb Image-r8a7797-v3msk-kf-v0.dtb Image-r8a7797-v3msk-vb.dtb
NOTE: you can refer to http://elinux.org/R-Car/Boards/Yocto-Gen3-ADAS#Build_scripts_examples section and use scripts after adding append from steps 8,13
Build SDK
Please follow these instruction to build SDK http://elinux.org/R-Car/Boards/Yocto-Gen3-ADAS#Build_SDK
Flashing firmware
TBD
U-Boot Environment
Please follow these instruction to boot from network http://elinux.org/R-Car/Boards/Yocto-Gen3-ADAS#Loading_kernel_via_TFTP_and_rootfs_via_NFS
For V3MSK board you must use one of the following dtb files:
Image-r8a7797-v3msk.dtb Image-r8a7797-v3msk-kf.dtb Image-r8a7797-v3msk-kf-v0.dtb
ADAS test applications
TBD