R-Car/Boards/Yocto-Gen3-CommonFAQ/The error message "NOTICE: BL2: Failed to DRAM initialize (-1)" is shown in IPL or kernel log stops the "Starting kernel ..."

From eLinux.org
< R-Car‎ | Boards/Yocto-Gen3-CommonFAQ
Revision as of 17:57, 24 December 2020 by Y.H. (talk | contribs) (Created page with "== The error message "NOTICE: BL2: Failed to DRAM initialize (-1)" is shown in IPL or kernel log stops the "Starting kernel ..." == Ex.) Error log: <syntaxhighlight lang=tex...")
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to: navigation, search

The error message "NOTICE: BL2: Failed to DRAM initialize (-1)" is shown in IPL or kernel log stops the "Starting kernel ..."

Ex.) Error log:

[    0.000148] NOTICE:  BL2: R-Car H3 Initial Program Loader(CA57)
[    0.004588] NOTICE:  BL2: Initial Program Loader(Rev.2.0.4)
[    0.010121] NOTICE:  BL2: PRR is R-Car H3 Ver.2.0
[    0.014788] NOTICE:  BL2: Board is Starter Kit Rev.1.0
[    0.019901] NOTICE:  BL2: Boot device is HyperFlash(80MHz)
[    0.025327] NOTICE:  BL2: LCM state is CM
[    0.029367] NOTICE:  BL2: AVS setting succeeded. DVFS_SetVID=0x53
[    0.035357] NOTICE:  BL2: DDR3200(rev.0.37)
[    0.050627] NOTICE:  BL2: [COLD_BOOT]
[    0.514068] NOTICE:  BL2: Failed to DRAM initialize (-1).
[    0.000148] NOTICE:  BL2: R-Car H3 Initial Program Loader(CA57)
[    0.004588] NOTICE:  BL2: Initial Program Loader(Rev.2.0.4)
[    0.010121] NOTICE:  BL2: PRR is R-Car H3 Ver.2.0
[    0.014789] NOTICE:  BL2: Board is Starter Kit Rev.1.0
[    0.019901] NOTICE:  BL2: Boot device is HyperFlash(80MHz)
[    0.025327] NOTICE:  BL2: LCM state is CM
[    0.029367] NOTICE:  BL2: AVS setting succeeded. DVFS_SetVID=0x53
[    0.035357] NOTICE:  BL2: DDR3200(rev.0.37)
[    0.050627] NOTICE:  BL2: [COLD_BOOT]
[    0.514070] NOTICE:  BL2: Failed to DRAM initialize (-1).
[    4.999792] ERROR:
[    5.000585] ERROR:   BL2: System WDT overflow, occured address is 0xe6304780

Check the Starter Kit and loader combination is correct.

See also: