Difference between revisions of "R-Mobile/Boards/APE6-EVM"
< R-Mobile
m (Move 1.8V warning to comment column) |
m (Add missing 0 prefix for Samtec connector) |
||
Line 56: | Line 56: | ||
|GND | |GND | ||
|X8 pin 28 | |X8 pin 28 | ||
− | |Samtec QTE- | + | |Samtec QTE-020 |
|Needs [https://git.kernel.org/pub/scm/linux/kernel/git/geert/renesas-drivers.git/commit/?h=topic/board-farm&id=379debff99d5fdfd190d3442424af09bbabeae43 ARM: dts: ape6evm: Enable PORT1 for wake-up] | |Needs [https://git.kernel.org/pub/scm/linux/kernel/git/geert/renesas-drivers.git/commit/?h=topic/board-farm&id=379debff99d5fdfd190d3442424af09bbabeae43 ARM: dts: ape6evm: Enable PORT1 for wake-up] | ||
|- | |- | ||
|} | |} |
Revision as of 02:26, 22 September 2017
Renesas APE6-EVM
Introduction
This is the Wiki for the Renesas R-Mobile APE6 APE6-EVM board. Refer to the R-Mobile page for information about Renesas' R-Mobile SoC family.
Serial Console
Use a micro-USB cable to connect to "Console". Serial settings are 115200 8N1.
Booting Linux
* Kernel config: shmobile_defconfig * Kernel image: arch/arm/boot/uImage * DTB: arch/arm/boot/dts/r8a73a4-ape6evm.dtb
Create a uImage:
make LOADADDR=0x40008000 uImage
U-Boot boot command:
tftp 40f00000 r8a73a4-ape6evm.dtb tftp 41000000 uImage bootm 41000000 - dtb 40f00000
Remote Control
Operation | Signal A | Pin A | Signal B | Pin B | Connector needed | Comments |
Reset | JTAG nSRST | X12 pin 15 | GND | X12 pin 16 | 2-pin female Mini-PV | nSRST is an 1.8V signal! |
Wake-Up | PORT1/DU0_DR1 | X8 pin 16 | GND | X8 pin 28 | Samtec QTE-020 | Needs ARM: dts: ape6evm: Enable PORT1 for wake-up |