R-Mobile/Boards/Armadillo-800-EVA

From eLinux.org
< R-Mobile
Revision as of 02:17, 22 September 2017 by Geert (talk | contribs) (Add Remote Control)
Jump to: navigation, search

Atmark Techno Armadillo-800 EVA

Introduction

This is the Wiki for the Renesas R-Mobile A1-based Atmark Techno Armadillo-800 EVA board. Refer to the R-Mobile page for information about Renesas' R-Mobile SoC family.

Serial Console

Use a serial cable to connect to "CON22". Serial settings are 115200 8N1.

Booting Linux

 * Kernel config: shmobile_defconfig
 * Kernel image: arch/arm/boot/zImage.dtb
 * DTB: arch/arm/boot/dts/r8a7740-armadillo800eva.dtb

Create a zImage with appended DTB:

make zImage dtbs
cat arch/arm/boot/zImage arch/arm/boot/dts/r8a7740-armadillo800eva.dtb > arch/arm/boot/zImage.dtb
# Hermit seems to drop the last byte if size is odd
dd if=/dev/zero bs=16 count=1 >> arch/arm/boot/zImage.dtb

Hermit-At boot command:

tftpboot <armadillo-ip-addr> <server-ip-addr> --kernel=zImage.dtb

Remote Control

Operation Signal A Pin A Signal B Pin B Connector needed Comments
Reset JTAG nSRST CON6 pin 15 GND CON6 pin 16 2-pin female Mini-PV
Wake-Up PORT95 CON15 pin 52 GND CON15 pin 38 Solder 2.54mm pin header + 2x 1-pin female Mini-PV Needs ARM: dts: armadillo800eva: Enable PORT95 for wake-up